How to Tile a Corner Shower Unit

  • Peter Selby
  • Tagged , ,
  • July 23, 2015
  • Tiling a corner shower device is a difficult task since of the area restrictions. Because corner showers are meant to save space, tiling them requires the do it yourself to handle a little working area inside the shower. Before setting the tiles, it ought to be kept in mind that the corner shower system needs to be set up with a shower pan and liner along with backer boards. Without the backer boards, the tiles will certainly not have a foundation where to be set. Right here are directions on how to tile a corner shower unit.

    Step 1 – Planning

    Plan the tiling initially. The wall can be set up with larger tiles in order to make the tiling procedure a lot quicker. For the floor, never make use of large tiles due to the fact that it will impact the slope. Use smaller sized tiles instead. Doing this will certainly permit the water to slope toward the drain. When tiling the corner shower device, constantly start with the floor before continuing to the walls.

    Step 2 – Setting the Mortar Bed

    Mix the mortar with water to the correct consistency. Always follow procedures on the item description for guidance. Prior to applying the mortar bed, check if the drain is well-covered. Apply the mortar and allow it to slope slightly towards the drain. Give the mortar to dry for 24 hours.

    How to Tile a Corner Shower Unit
    How to Tile a Corner Shower Unit

    Step 3 – Tiling the Floor

    Figure out the number of tiles needed for the floor tiling and cut the tiles if needed. Prepare thinset mortar by following the maker’s guidelines. Purchase pre-mixed thinset in order to make the procedure simpler. Apply the thinset accordingly on the floor and install the tiles piece by piece. Await the thinset to cure. Clean the extra grout with moist sponge and wait for the grout to treat prior to continuing with the walls.

    Step 4 – Tiling the Walls

    Start by marking the bottom row with a pencil. Mix an enough quantity of thinset mortar just enough for the bottom row tiles. Utilize the trowel to use the thinset at the bottom and lay each tile accordingly. To offer constant spacing between the tiles, location spacers in between them. Wait for the bottom row of tiles to set for about 6 hours or so prior to setting up the succeeding rows.

    Continue with the being successful tiles by following the fundamental treatment of applying thinset and laying the tiles. Use spacers on all sides of the tiles to come up with consistent spacing. For the top row, cut the tiles accordingly. Permit the thinset to cure for about 48 hours prior to grouting. Wait for the grout to cure, and you now have a tiled corner shower system.