How to Install Ceramic Tile

  • Peter Selby
  • Tagged , ,
  • July 22, 2015
  • A ceramic floor is one of the most resilient, appealing and low-maintenance floors available. Although it might be a lengthy, grueling task, the completed project will certainly be worth it. Below is a standard outline of the installation steps.

    Preparing

    Get rid of the old flooring and baseboard molding and take a look at the sub floor. The sub floor must be at least 1 1/8″ thick and have no versatility. It is best to install cement board on top of the plywood sub floor to guarantee its stability.
    Step the square video footage of the room be multiplying one side of the room by the other. For instance: a 12 by 12 space is 144 square feet. Then include 10 % to that number making up for tile breakage. The final number is the amount of tile had to finish the task. In this circumstances the last number will certainly be 158.4 square feet.

    Discover a Starting Point

    Start tiling in the middle of the space so that any little, cut pieces wind up on the edges of the room. To discover the middle of the space snap a chalk line from the center of opposite walls. The lines should cross in the middle of the room, marking your starting point.

    Laying the tile

    Lay out a line of tile along each of the chalk lines before using mortar. Get a concept of the pattern prior to committing.

    After choosing a design, mix the mortar per the manufacturers instructions. Using a notched trowel, spread out a thin coat of mortar in a 2×2 foot section. Place the tiles thoroughly on the mortar and use tile spacers to keep the distance between each tile accurate. You need to use a notched trowel for two factors: 1. the ridges that it produces in the mortar suction the tile to the floor and 2. the air area in between the ridges help the mortar dry. To guarantee that the tiles are level use a rubber mallet and tap the tile into location. Use a level to double check your work.

     How to Install Ceramic Tile
    How to Install Ceramic Tile

    Cutting Tile

    The most accurate method to cut tile is with a damp saw. A damp saw works like a table saw, however has a supply of water working on the blade to keep it cool. A tile cutter is also an option, but there is a propensity to using them and it will take some practice to get an ideal cut.

    Grouting

    Let the tile and mortar dry for at least 24 Hr prior to grouting. Mix grout according to the producer’s directions. Press the grout into every crevice at a 45 degree angle utilizing a grout float. Wipe off any excess with a tile sponge. Rinse the sponge frequently. Work in small areas. Try not to obtain excessive on the tile, considering that it is virtually difficult to get it off as soon as dried. There will be a haze left on the tile, however that can be washed off when the grout is cured.

    Dry and Seal

    It may sound amusing, but grout requires some wetness to dry correctly. To cure it correctly wash the floor with a sponge mop once a day for 3 days. Use the sealer after the third day to the grout only.

    Completing Touches

    Put the base board back on and you’re done! Now stand back and appreciate your work!